– Enter binary to enable a binary mode transfer. – When prompted for an account and password, specify the grpadmin account and password. Type open, followed by the IP address of the array to open a connection.Only the grpadmin account can update group firmware. Log in to the array using the grpadmin account. Connect through an IP address assigned to a network interface on the array (for example, Ethernet Port 0). (Optional) Shut down the hosts accessing group volumes.Ĭonnect to the array using telnet, SSH, or a serial connection. Updating Storage Array Firmware Upgrading the Firmware Using the CLI: See CLI Output Examples on page 12 for examples of the screen output shown during this process.If the FW Rev values for the two controllers do not match, contact Dell Technical Support. On arrays with dual control modules, both control modules must be running the same firmware.On an array with dual control modules, the update command updates both control modules.If you are using a serial connection, use the characteristics stated in the CLI Reference guide. You can use the CLI to upgrade the firmware as an alternate method to using the GUI.Ĭonstraints and Prerequisites for Using the CLI Upgrading the Equallogic Firmware Using the CLI
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |